Switch SW1 has been configured with Private VLANs. With that type of PVLAN port should thedefault gateway be configured？（）
A network technician is installing a new managed 10/100 Mbps switch on the network. The network has an older printer with a 10Mbps network adapter that will be moved to the new switch.Which of the following settings on the switch will need to be configured to support the printer?（）A. MAC filteringB. IP addressC. PoED. Port speed
点击查看答案
A company is experiencing network delays. The network administrator discovers that a worker in a location far from the MDF has connected an old 10BASE-T switch with redundant links to the existing network.How could this action be responsible for the impaired network performance?（）A. Connecting a host to the old switch has created a broadcast storm.B. The 10BASE-T switch forced the entire network to be reduced to 10 Mbps operation.C. The old switch does not support VLANs, which has disabled the VLAN configuration of the entire the network.D. The old switch does not support full-duplex operation, effectively forcing half-duplex operation throughout the network.E. Spanning Tree Protocol has elected the old switch as the root bridge, creating inefficient data paths through the switched network.
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A. oneB. threeC. twoD. zero
Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0／10 is not the root port for VLAN 2?()A.This switch has more than one interface connected to the root network segment in VLAN 2.B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.C.This switch interface has a higher path cost to the root bridge than another in the topology.D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.
Refer to the exhibit. Based on the information given. Which switch will be elected root bridge and why?()A.Switch A ,because it has the lowest MAC addressB.Switch C,because it has the lowest priorityC.Switch B,because it has the highest MAC addressD.Switch C,because it is the most centrally located switchE.Switch A,because it is the most centrally located switchF.Switch D,because it has the highest priority
A lightweight access point has been connected to a Catalyst 3550 24-PWR switch， and on power-up the access point fails. What is the problem with the switch？（）A、The power supply has inadequate wattage.B、Power is incorrectly configured on the port.C、It does not support 802.3af Poe.D、Power is not enabled on the port.
A new Catalyst switch is connected to an existing switch using a crossover cable. As a result of this, what would the switch port link lights display?（）A、The switch port link lights will be off on both switches indicating the ports are not connected.B、The switch port link light will be off on one switch indicating that STP has disabled the port.C、The switch port link lights will flash amber indicating an error.D、The switch port link lights will be green indicating normal operation.
